Nabertherm Gradient or Lab Strand Annealing Furnace GR 1300/13
The furnace chamber of the gradient furnace GR 1300/13 is divided in six control zones of equal length. The temperature in each of the six heating zones is separately controlled. The gradient furnace is usually charged from the side through the parallel swivel door. A maximum temperature gradient of 400 °C can then be stabilized over the heated length of 1300 mm. On request the furnace also is designed as a lab strand annealing furnace with a second door on the opposite side. If the included fiber separator are used charging is carried-out from the top.
- Tmax 1300 °C
- Heated length: 1300 mm
- Heating elements on support tubes providing for free heat radiation in the kiln chamber
- Charging from the top or through the right side door
- Gas damper suspension of the lid
- 6-zone control
- Separate control of heating zones (each 160 mm long)
- Temperature gradient of 400 °C over the entire length of the kiln chamber, each zone can individually be controlled
- Fiber separators dividing the chamber in six equally sized chambers
?
?Additional equipment
- Up to ten control zones
- Second parallel swivel door for use as lab strand annealing furnace
- Vertical instead of horizontal strand furnace
- Process control and documentation via Nabertherm Control Center (NCC) for monitoring, documentation and control
Controller: H 1700
Width outside (oven):
|
1660 mm
|
Width inside (oven):
|
1300 mm
|
Height outside (oven):
|
1345 mm
|
Height inside (oven):
|
60 mm
|
Power (oven):
|
18 kW
|
Stove appliance type:
|
gradient- /lab strand annealing furnace
|
Oven temperature max.:
|
1300°C
|
Depth outside (oven):
|
740 mm
|
Depth inside (oven):
|
100 mm
|