ELGA PURELAB 7060

Model	PURELAB 7060
Treated Water Specifications
Make-up rate at 15°C	60 l/hr
Daily usage - typical	480 liters
Daily usage - maximum	1440 liters
Delivery flowrate	Up to 4 l/min at 12 psi (0.8 bar) 1)
Inorganics rejection	-
Inorganics (resistivity at 25°C)	>15 MOhm-cm
Bacteria - typical	<1 CFU/ml
Organics (TOC) - typical	<10 ppb
Particles	0.05 µm
Dimensions and weights
Dimensions	Height 820mm (32.8in) 834mm (33.4in) including castors Width 794mm (31.8in) Depth 470mm (18.8in)
Supply weight	52kg
Operational weight	109kg
Installation	Floor/bench
Feedwater Requirements
Source	Tap water as detailed below
Contaminant
Conductivity	<2000 µS/cm*
Hardness	<250 ppm as CaCO3
Free chlorine	<4 ppm Cl2
Chloramine	<1 ppm as Cl2
Silica	<30 ppm SiO2
Fouling Index	<10 FI
Iron/manganese	<0.1 ppm Fe/Mn
Organics	<3 ppm TOC
Temperature	4 - 40°C (Recommended 15 - 25°C)
Flowrate (maximum requirement at 15°C)	9 l/min
Drain requirements (gravity fall with air gap)	20 l/min
Feedwater pressure	6 bar (90 psi) maximum 2 bar (30 psi) minimum
Electrical Requirements
Mains input	230V ac, 50Hz 115V ac, 60Hz
System control voltage (not including pumps and UV)	24V dc
Power consumption (peak demand)	650VA
Electrical protection rating	10 amps

Specifications are for a system fed with a suitable water supply and installed, operated and sanitized according to the operator manuals.
¹⁾ With High Flow Kit (LA723) or 2 l/min at 12 psi (0.8 bar) without high flow kit

Failure to comply with the feedwater pretreatment recommendations will affect the life and performance of key components and may invalidate the warranty. Feedwater requirements are specified for units fitted with a Protek L2 pretreatment cartridge. If feedwater purity is variable or values are outside any of the above ranges, additional pretreatment is recommended to be installed in the feedwater supply to the unit.

^* Deionization cartridge life may vary with feedwater >1400 µS/cm